Add some excitement to any outfit by accessorizing with this magnificent bracelet. Featuring beautiful Swarovski crystals from the Wanderlust Innovations Launch.
Designer: Judy Payne
Level: Beginner
Components:
- 2-Hole Spike Bead A5060MM07.5LIGHTCHROME – 8 pieces
- Tube Bead A5950MM30LIGHTCHROME/STEEL – 1 piece
- Bicone A5328MM05MAJESTICBLUEAB – 14 pieces
- Briolette A5040MM04SCARABAEUSGREEN – 16 pieces
- 12mm Lobster Clasp – 1 piece
- 2 Crimp Beads
- 2 Jump rings
Instructions:
- Cut 2 strands of stringing cord approximately 12” each
- Crimp both strands at one end forming a small loop.
- String both cords through a single bicone.
- Thread on 1 x 2-hole spike bead.
- On each cord add 1 x bicone.
- On each cord add 1 x briolette.
- Repeat steps 4 to 6.
- On each cord add 1 x briolette.
- On each cord add 1 x bicone.
- On each cord add 1 x briolette.
- Thread on 1 x 2-hole spike bead.
- Join the 2 cords together and add 1 x Tube Bead
- Do steps 3 through 11 in reverse to complete the other side of the bracelet.
- Crimp the remaining end of a toggle clasp to the end of the 2 strands of stringing cord leaving a bit of slack so that the bracelet can form around the wrist.
- Trim off the excess beading cord.
- On one end add a jump ring and on the other add a jump ring and a lobster clasp.
Finished length is approximately 7.5″. Add or remove beads to alter the finished length.
